How To Install A Hose Bib In A Mobile Home

How to Make a Hose Connectedness in a Mobile Home

A mobile dwelling, a house constructed on a frame with wheels, tin have hose connections installed on all four exterior walls. The clamber space nether a mobile domicile has 2 feet to 3 feet between the ground and the floor to piece of work in. The plumbing pipes run tight to the floor in this space. According to the U.S. Environmental Protection Agency, 10 percent of homes in the United States waste at least 90 gallons of h2o each day, only following these instructions closely can forestall leaking.

A mobile home can have a hose connections added.

Turn off the water to the mobile home at the water meter. Open a faucet to relieve water force per unit area.
Use tubing cutters to cut a 2-inch department from the mobile domicile's principal h2o line between the h2o meter connectedness pipe and the outset branch line. Permit the water to bleed from the cut pipes. The main plumbing line volition have its size, commonly 3/4 inch or i inch, marked on the side of the pipage. A plumbing branch line leads to a faucet, toilet, hose bib or water heater.
Connect a CPVC compression tee plumbing fixtures to the main water line at the cuts. Aim the side port in the management of the new hose connection. Utilize an adjustable wrench to tighten the slip nuts on the compression fittings. Compression fittings can connect to different pipe materials. The correct tee fitting will have the same line size as the main water line and accept a ane/2-inch port exiting the side.
Use a record measure to find the altitude from the tee fitting to the wall where the new hose connector volition mount. Add 1 inch to this measurement for the pipe'south full length.
Cutting a slice of ane/2-inch CPVC pipe at the total length measurement. Utilise tubing cutters to cut the piping.
Install the 1/ii-inch CPVC pipe into the side port of the compression fitting. Tighten the compression fitting nut with an adjustable wrench.
Place hanging straps every 5 feet along the ane/2-inch CPVC pipe. Screw the straps in place with a drill and one-inch screws.
Clean the end of the pipage and the plumbing fixtures that will connect to the pipe with CPVC primer. The lid volition take a brush connected to it. If the pipe does not achieve the outside of the mobile home, then clean a 1/two-inch CPVC coupling. If the pipe extends by the wall, then make clean a 1/ii-inch CPVC male person plumbing equipment.
Apply CPVC glue to the pipe and the plumbing fixtures. The lid will take a brush connected to it.
Slide the plumbing fixtures onto the piping with a twisting motion. Keep pressure on the fitting for threescore seconds. Extend the pipe every bit necessary with couplings and hanging straps until the end reaches the exterior wall where the pipe will require the male fitting.
Encompass the CPVC male plumbing equipment'due south threads with a pipe thread compound. The lid will have a castor connected to it.
Screw a hose bib connector onto the male plumbing fixtures until information technology's tight. Place an adjustable wrench on the CPVC male plumbing fixtures. Tighten the hose bib connector two full turns with the second adjustable wrench. The hose connection on the hose bib should face downwards.
Utilise a drill to secure the hose bib to the mobile habitation with 1-inch screws.
Turn the water to the mobile home on at the water meter. Check for leaks.